Trouble fitting the pricepart inner primary

Clutches, Chain & Belt Drives

Moderators: Dan J, Stuart, Diesel Dave, Crazymanneil

Trouble fitting the pricepart inner primary

Postby arnaud » Tue Jun 09, 2015 11:00 am

.. in building a yanclone with the priceparts subframe and inner primary, i am busy for many ours shimming the engine so that the gearbox shaft can spin- more or less- freely in the inner primary bush bearing..
Not any progress so far,,
once setting it okay, fastening the 4 bolts, secureing the engine and there's a lot of strain again on the shaft..
can anyone give me a tip? or is the a ball bearing possible in this place?
arnaud
I luv the smell of Diesel...
 
Posts: 330
Joined: Tue Apr 29, 2008 11:11 am

Return to Clutch, Primary & Final Drive

Who is online

Users browsing this forum: No registered users and 1 guest